How to Apply Golf Club Wraps – Surface Pro Complete Guide
WHAT YOU NEED
Aside from your golf club and Crown Wrap, you will need the included knifeless tape, scissors, an alcohol wipe or degreaser, a lint-free cloth, and a heat gun or hairdryer.
CLEAN THE CLUB HEAD
Use an alcohol wipe or degreaser and a lint-free towel to remove all dirt, grass, and debris from the surface.
CUT KNIFE-LESS TAPE
Measure and cut approximately 55 cm of knifeless tape. At one end, separate approximately 20–30 mm of the filament from the backing so that it can be accessed easily later.
APPLY THE KNIFE-LESS TAPE
Apply the tape along the natural edge of the clubhead, keeping it on the outer side of the crown. Leave enough tape extending beyond both ends so that the filament remains easy to access later.
POSITION THE SKIN
Peel the backing from the vinyl and position the wrap over the crown. Use the notch to align it with the hosel and the front edge of the clubhead. Reposition as necessary until you are satisfied with the placement.
WORK THE VINYL
Starting at one end, use your fingers to smooth the vinyl across the crown, gently stretching it only as necessary to remove wrinkles. Make sure the vinyl extends beyond the knifeless tape around every edge.
PEEL OFF KNIE-LESS TAPE
Grip the exposed filament at the end of the knifeless tape and pull it smoothly through the vinyl to trim the excess. Keep firm pressure on the vinyl and tape backing as you pull to create a clean, continuous cut.
APPLY HEAT
Apply gentle heat on a low setting while smoothing the vinyl with your fingers to remove any remaining wrinkles. Press firmly around the edges to secure the wrap and improve durability. Avoid overheating the vinyl or clubhead.
READY FOR USE
Your wrapped golf club is ready to use immediately—no curing time is required. Enjoy its new look and play with confidence.
- Before applying the tape, separate approximately 20–30 mm of filament from the backing at one end.
- Make sure the vinyl is firmly adhered over the knifeless tape around the entire clubhead before pulling the filament.
- Hold the vinyl firmly against the clubhead with your thumb at the starting point while pulling the filament smoothly through the vinyl.